08000145 - Workhorse Starter Asm (New)

 The state of California requires that this warning be posted for people purchasing products that reside in California.

WARNING: Products may contain one or more chemicals known in the State of California to cause cancer and/or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov

Installation Procedure

1. Install the starter heat shield, nut and bolts if necessary.

   Tighten

   D Tighten the starter heat shield bolts to 3 N@m (35 lb in).

   D Tighten the starter heat shield nut to 5 N@m (44 lb in).

2. Install the starter motor bolts.

   Tighten the starter motor bolts to 50 N@m (37 lb ft).

3. Install the engine harness to the starter.

4. Install the engine harness nut.

   Tighten

   Tighten the engine harness nut to 2 N@m (18 lb in).

5. Install the positive cable to the starter.

6. Install the positive cable nut.

   Tighten

   Tighten the positive cable nut to 10 N@m (89 lb in).

7. Lower the vehicle.

8. Connect the negative battery cable.